About  |  Support  |  Contact |  Reviews  |  FAQ
 

VFORCE TLSO Support

VFORCE TLSO MODEL NUMBERS

CERTIFICATION L0637

_________

MODEL #VFFTLSO2012: 

Standard Back Piece 15 1/2″ H

 

MODEL #VFFSTLSO2012: 

Standard Back Piece 11 1/2″ H (Special order for patients under 5’2″)

VFORCE TLSO SIZING CHART

_________

How to Fit the VFORCE TLSO BACK BRACE

STEP 1

Insert straps over shoulders.

STEP 2

Position the belt around the torso making sure the back panel is centered in the low back area.

STEP 3

Hold the left abdominal flap firmly with the left hand over the abdomen.

STEP 4

Grasp the right flap with the right hand and stretch the corset outwards, then wrap around the body. Attach flap securely onto the first flap over the abdomen. Verify the corset is fitted correctly by checking the position of the front flexible stays; they should be positioned equidistant from the navel.

STEP 5

Grasp the lower side straps and pull simultaneously until the required tension is achieved, then fasten them to the abdomen.

STEP 6

Repeat this step to adjust the upper side straps.

STEP 7

Fasten center chest strap.

STEP 8

At this point brace should be comfortable and secure. If additional adjustments are required, pull straps accordingly to desired compression.

STEP 9

Pull front straps straight down to desired tension.

STEP 10

To achieve maximum comfort and support, height of brace can be altered by adjusting strap on back of harness (See yellow arrow).

TLSO How-To’s

WATCH HOW TO FIT THE VFORCE TLSO BRACE

https://www.youtube.com/watch?v=zs2it0JRLbI

WATCH HOW TO FIT THE VFORCE TLSO BRACE

  • No special maintenance is required.
  • By laying the brace on a flat surface, remove the 4 plastic disks from the waist panel. Then, flip the brace over and open the mesh back piece, remove the back panel and slip the cover off. Before washing, make sure all velcro is in locked down position and place in mesh bag. (This will prevent any snagging.)
  • Hand wash or machine wash (gentle cycle only) in warm water. Wash separately, do not use bleach or chlorine products. Mild detergent and fabric softener only. Use extra spin cycle to remove excess water if needed.
  • Hang to dry or use dryer on low heat. (Make sure all velcro is locked in place to prevent snagging.)
  • When dry, re-insert panels and brace is ready to wear.

STILL HAVE QUESTIONS ABOUT VFORCE TLSO BACK BRACE?